arduino case with mounting flaps and layers for dm diymore clone ukulele mount providing complete coverage of the

providing complete coverage of the bicycle chain

This specific part was designed because my Blackmagic Design Pocket Cinema Camera does not have a hot shoe/cold shoe

although this is not recommended

Our drilling rail helps with accurate drilling for bolts and bolt caps

place a piece of tape on the drawer front to mark the center of the drawer

arduino case with mounting flaps and layers for dm diymore clone ukulele mount providing complete coverage of theThis is a case for the DM DIYMORE arduino clone. Some arduino models may vary slightly in size and the location of the connectors. There is plenty of room inside the case for wires and other small items. Use small self tapping screws for the arduino and the lid. 4 markings have been made for cable drilling holes so they can be in the same location if you make several cases for a project. The mounting tabs are 40 mm wide and fit an M5 hex bolt. I use